Making correct doorframes?
Created 8 years ago2015-12-28 01:58:20 UTC by
Spreen
Created 8 years ago2015-12-28 01:58:20 UTC by
Spreen
Posted 8 years ago2015-12-28 01:58:20 UTC
Post #327934
I want to make a doorframe for my door in Jackhammer, but I have a slight problem. It's hard to actually make the sides for my doorframes.
Posted 8 years ago2015-12-28 02:44:53 UTC
Post #327935
Not sure about jackhammer, but you need to apply the texture to all faces.
Either that or use a different texture.
Either that or use a different texture.
Posted 8 years ago2015-12-28 18:55:02 UTC
Post #327940
use hammer...
Posted 8 years ago2015-12-29 01:47:20 UTC
Post #327947
Not entirely sure what the question is.
Posted 8 years ago2015-12-29 02:22:50 UTC
Post #327948
If you're asking what I think you're asking, try using a different texture similar to the trim texture, but without any of the details — a plain one.
You must be logged in to post a response.