One brush shapes. Created 20 years ago2004-08-14 14:58:25 UTC by paulkennedy

Is it possible to make a single brush in the shape of a cube with a corner taken off for example? If you use the carve tool it cuts it into two peices and if you use the clip tool it screw it up really badly.

Yes, though it involves the clipping tool.

By clicking on the tool in the toolbar it changes the clip mode, from alternating which side to hack off to just splitting the brush. Keep that in mind and I'm sure you can find a way to make it work.

if you're talking about a corner at an angle, and not straight on in the grids, then you'll need to make at least two or three brushes

Do what Rabid said, unless you want it curvy, then do what Peace said.

Sorry, I wasn't very clear. What I meant was not a corner sliced of in one stroke, I meant like a square chunk.
For a better example, is it possible to make a cross out of one brush?

i dont think so... :

It is. In a way.
You must be very practised with the vertex tool, otherwise you'll get coplanar faces and invalid solid structures.
Why do you actually want this? It wont give you any advantages compared to making it out of multiple brushes.

Fun! In a certain way, it can actually be achieved in the editor without getting errors.

During the compile however, the brush is made convex. So, no, it's not possible.