?
Memory Allocation error
Created 19 years ago2004-07-23 15:27:41 UTC by
davideo59
Created 19 years ago2004-07-23 15:27:41 UTC by
davideo59
Posted 19 years ago2004-07-23 15:27:41 UTC
Post #44076
I keep getting this "memory alocation error" when compiling in the middle of qrad. I doesnt have to do with my computer does it ?
?
Posted 19 years ago2004-07-23 15:32:12 UTC
Post #44078
What are your system specs?
Posted 19 years ago2004-07-23 16:14:39 UTC
Post #44094
512 ram, 2-3ghz P4 proccessor, 128 graphics - cant think of anything else important about system. ive got enefough hard drive space - 13 gig
Posted 19 years ago2004-07-23 20:17:56 UTC
Post #44168
Good ol' Tommy has a reply:
[quote]
Memory allocation failure
Description: The program failed to allocate a block of memory. Likely causes are (in order of likeliness):
[quote]
Memory allocation failure
Description: The program failed to allocate a block of memory. Likely causes are (in order of likeliness):
- Do not compile thru WC/Hammer F9 "running" - this hogs RAM. Instead use a front end or batch file to organize your compiling
- The partition holding the swapfile is full (clean out your hard drive, empty trash, clear out unused files, purge your temp files folders and internet browsers temp files.)
- Swapfile size is smaller than required (let swapfile be dynamicly allocated, do not set it too small yourself.)
- Memory fragmentation (defrag your hard drive)
- Heap corruption (reboot and try again. If you have old RAM, make sure it is seated well. check for viruses!).
- On at least one occasion this was caused by a corrupt prefab.
- On at least one occasion this was solved by removing a skybox and so making the level smaller. [/quote]
Posted 19 years ago2004-07-24 02:17:42 UTC
Post #44253
lol its going to take a while to go through all those but thanks 
You must be logged in to post a response.