Working on some movie editing for a mod and ran into a problem that I couldn't seem to solve. I am trying to get multiple camera set up for my cinematic each with a fade-in effect. I noticed that the first camera automaticly sets up a fade-in effect but when it switches to the second camera that effect isn't activated. I was wondering if I could control this effect or if it was out of my control. I'm using the Hammer Editor version 3.5. Maybe Spirit of Half Life or other editor would have control over this effect. Any help or advice is great and appreciated. Thank you in advance. Also, when I try to put multiple cameras under one multimanager, I experience the following problem. First, I get the normal cinematic working on the first camera, but everyone working after that only flashes for a millisecond and goes through the wait time until it gives a flash of the next one. Any help in either of these problems is greatly appreciated. I haven't done a lot of cinematics in mapping so I would like to get some experience in that skill. Thank you.