No map on server Created 19 years ago2004-11-13 23:35:59 UTC by digitalmonk

Uh...so I set up my hammer to put compiled maps into the half life valve maps fodler where its sposed to go.

Doesnt always make a BSP fiel! THis happens for condition zero and CS too,

what gives??? It doesnt happen consistently enough that Ican find a pattern.

RAAAR

also, it seems that when this problem happens.....it sometimes doesnt even make a BSP!!!!!!!!!!

** Executing...
** Command: C:PROGRA~1VALVEH~1TOOLSQCSG.EXE
** Parameters: "C:SIERRAHalf-Lifevalvemapsfriggindoors"

qcsg.exe v2.8 (Jan 31 2000)
-- qcsg --
entering C:SIERRAHalf-Lifevalvemapsfriggindoors.map
Entity 0, Brush 38: origin brushes not allowed in world
********** ERROR **********
missing '[ in texturedef

** Executing...
** Command: C:PROGRA~1VALVEH~1TOOLSQBSP2.EXE
** Parameters: "C:SIERRAHalf-Lifevalvemapsfriggindoors"

qbsp2.exe v2.2 (Dec 28 1998)
-- qbsp2 --

********** ERROR **********
Can't open C:SIERRAHalf-Lifevalvemapsfriggindoors.p0

Switch over to ZHLT for a start. These tools replace the Q(uake) tools that you are using. Go to our Link page to find them.

Once you get them and start using them, check this site for info on your error.

Okay well i switched to those tools and hammer crashes and it still doesnt make a bsp

No, Hammer doesn't crash, you're impatient.

If it doesn't compile, read your own log, look at Tommy14, and if all else fails (and only then), post your log.

Well I'll tell you what Seventh, I'd make sure I knew who I was talking to before insulting them with trite accusations such as that I wouldn't know if somehting had crashed or not.

The PIC says you're wrong.