GREEN FENCE?! Created 19 years ago2005-02-12 01:34:50 UTC by JujitsuMan

i'm not a newb mapper, i'm intermediate at least, but this problem has completely bewildered me. I compile my map, do all the stuff, blah blah. The only fence that's in there all of a sudden turns green!. It's a green fence. I look above it. The little bar i put as a top is also green on one side (the side that's facing same as fence) and bottom is blue.

So i open up the console to see if i can fix it. Only one error. Says that occlusion could not be found in it's material_occlusionproxy area. Only problem is, i don't remember putting an occlusion effects in my map.

You may have used a texture that was meant for a model. Check the name of the texture: it may have the word "prop" in it. If it does, you'll need to change it.

Do you have env_cubemap placed in your map? Place one or two near the model and make sure you run buildcubemaps from the console once you have the map loaded in the game.

If this doesn't solve the problem, then it might be an issue with the driver of your graphics card. Updating the driver might solve the problem.

I have this problem sometimes and the only solution iv found is to change textures some of them are preety screwed for me.