Goldsource Error: Warning: ChopWinding: Rejected Last edited 16 years ago2008-04-26 14:57:24 UTC

You are viewing an older revision of this wiki page. The current revision may be more detailed and up-to-date. Click here to see the current revision of this page.

This article was converted from a previous version of TWHL and may need to be reviewed

  1. The formatting may be incorrect due to differences in the WikiCode processing engine, it needs to be revised and reformatted
  2. Some information may be out of date
  3. After the article is re-formatted and updated, remove this notice and the Review Required category.
  4. Some older articles are no longer useful, or they duplicate information from other pages. In this case, delete the page after merging any relevant information into other pages. Contact an admin to delete a page.
ORIGINAL TITLE: Warning: ChopWinding: Rejected(1) due to too many points
Merle says, "A winding is a data structure used in the compile tools to store a set of points. As
they are very versatile, they can be used to describe a number of things (surfaces, brush faces,
brush sides, whole brushes, etc...
). Your Warning (note: which is not an Error.) message is simply
alerting you to the fact that one of these winding data structures has a larger number of points than
expected, and one of the points was ignored.

"It is hard to guess what casues this as most of the typical causes (eg. brush sides with large
numbers of vertexes
) should be really caught earlier on in the process. Hence, it is most probably
the artifact of some subdivision or modification of the points of the map itself during the compile,
which makes it even harder to track down.

"I recommend using the 'Big Block' method of trying to isolate a particular area of your map that
causes it, and to modify/simplify/change the general brush geometry. This is a very generic fix,
but its also a very generic message."

Comments

You must log in to post a comment. You can login or register a new account.