Posted 19 years ago2005-10-19 16:36:06 UTCPost #142424
after fully compiling my map, as i enter a room with a cylinder, a couple of the segments of it dissapear, although you can see the face, there's no block underneath. any ideas. :
Posted 19 years ago2005-10-19 16:49:06 UTCPost #142426
Thats a well known glitch in HL. Happends when the vertices of the cillinder are off the grid. There is not much you can do about it, unless you make the cillinder on the grid without making a invalid structure.
Posted 19 years ago2005-10-20 10:33:46 UTCPost #142530
You can use the arch tool, then make sure that EACH vertex is on the grid. Or you can construct the cylinder from scratch with wedges as BrattyLord suggested. There's a tutorial on hollow cylindrical construction.
Posted 19 years ago2005-10-20 10:55:33 UTCPost #142535
another way of makeing your own cliender. clipping and VM. to fix the problem with it dissapering couldn`t you just use VM to move the points onto the grid? that tut is not for makeing pipes. its for makeing round holes without carving!(the outside you will find is square)
Posted 19 years ago2005-10-20 12:33:52 UTCPost #142555
Try re-making it and check for any invalid solid errors.. If it's an invalid solid - the best thing to do would be removing and remakin it. Dunno if you would be marked down for it.. Anyways you have time, so improve as much as you can!
Posted 19 years ago2005-10-22 11:39:45 UTCPost #142886
I would have closed it earlier, but I wasn't going to bother. I only close threads as soon as the issue's resolved when I can see them rambling off-topic. Like this one, now.
I wish people would use forum terminology properly. It's not hard.