Forum posts

actaully it takes like 30 seconds lol

you rock, microbrush solved...
only problem is i have a gap in the wall now easily fixed.
if you would like to see what i have for the map so far maybe find a fdew bugs i it and help me learn to fix things like this just let me know, thank you.

ProcessBlock_Thread: 0Brush 16529: WARNING, microbrush
...1...2..Brush 13936: WARNING, microbrush
.3...4...5...6...7...8...9...10 (0)
ProcessBlock_Thread: 0Brush 16529: WARNING, microbrush
...1...2..Brush 13936: WARNING, microbrush
.3...4...5...6...7...8...9...10 (0)

what the hell is this?

i did that Alt+P and the only problem is no spawn point for CT (which i knew coz i aint put in yet.
is there wa way to identify which brushes are causing these errors?
so i dont end up doing the entire front of the ship again (which by the way took longer than i hoped)

oooo beep wrong section... my bad ^_^
ill give that a go in a moment. ill edit this afterwards

i do a lot of carving
Carving was the only way i could get the shape of the drop ship

if someone could "fix" this problem for me i would happily senf the raw map file

OK this is the problem i have...

When i run the test map that i compile to have a look at it so far, there is some brushes on the map that are NOT there in hammer, you can walk through them. I can best describle them as Ghost Brushes.

How do i fix this? because i spent a lot of time shaping this dropship for it to cock up like this.