Curved Ramp Created 17 years ago2006-10-25 18:52:56 UTC by TawnosPrime

I just thought I'd show this off. I had tried to make this brfore and I had succeeded shortly after, I just never bothered to post it...at least I don't think I did.

This ramp curves to the right and, once finished, should look awesome.

looks nice, but I'd suggest allowing a small lip between the top of the sides and the forcefield itself.

Shows experience with brushes, good job to you

Thanx for the compliment, and I see what your getting at w/ the lowered forcefield. I'll have to have a look at doing that.

Agreed.

Also, the texturing on the inward facing side of the brush that touches the forcefield looks good at the bottom, then changes to the caution bar as you go up... I don't know if that was accidental or if you're not finnished texturing.

But other than that, I have'ta say, it looks pretty hot .

Curvelicious

Saw this over at the Dystopia forums. Nice. :>

Nice, but rather simple too make though, just a subdivided plane with a twist modifier .

Good job, i wonder how it will look in your map.

THanx for all the compliments guys.

The caution bar texture is the temp, RS. I started texturing it, but it's tricky to get the angles right to keep the flow going, so I'm going to finish it when I texture the rest of the map at the end.

Yeah, Trapt, I psoted there too for the guys over there to enjoy as well.

I'm not sure wtf you're talking about pepper. It sounds like you're refering to modelling or more advanced brushwork, while I don't know about.

Aye modeling Nice work again.