My machine apears at aprox. 45 degrees right!
WHY?
help with func_traktrain
Created 19 years ago2004-11-03 17:34:28 UTC by
Catalin
Created 19 years ago2004-11-03 17:34:28 UTC by
Catalin
Posted 19 years ago2004-11-03 17:34:28 UTC
Post #71342
Posted 19 years ago2004-11-03 17:39:52 UTC
Post #71344
.........care to......... elaborate?
Posted 19 years ago2004-11-03 17:45:15 UTC
Post #71347
what?
![[VDC] Rad Brad](https://twhl.info/uploads/avatars/small/315.jpg)
Posted 19 years ago2004-11-03 21:04:31 UTC
Post #71364
Are you sure you're standing on the correct side of it? It might be 45 degrees left....
![[VDC] Rad Brad](https://twhl.info/uploads/avatars/full/315.jpg)
Posted 19 years ago2004-11-03 21:16:49 UTC
Post #71365
Check the little compass in brush properties, make it an angle you liek.
Posted 19 years ago2004-11-04 09:47:14 UTC
Post #71450
You have to rotate the whole machine so its facing 90degrees. In Hammer...
This also happens when making Func_tanks or turrets.. so. yep that should fix it you see just rotate it in hammer so its facing 45degrees from the way it should be going.... I can't explain it any better... Ssoo
Experiment.
This also happens when making Func_tanks or turrets.. so. yep that should fix it you see just rotate it in hammer so its facing 45degrees from the way it should be going.... I can't explain it any better... Ssoo
Experiment.
Posted 19 years ago2004-11-04 15:06:55 UTC
Post #71550
func_tracktrains may need to face west in Hammer.
Posted 19 years ago2004-11-04 15:09:59 UTC
Post #71552
Same goes for func_tanks
You must be logged in to post a response.