texture application Created 19 years ago2005-03-17 14:48:58 UTC by J3r3my

when i use the texture application tool to apply a scaled texture (mode: texture + values) i set the values but after i apply it the values i entered go blank and i have to put it back in each time i apply a texture. its slow and annoying especially since my map has alot of faces. how can i get it to keep the values i put in?

I think textures are always applied to new faces at 100%x100%. You could clone the brushes instead by shift-dragging them, if that helps.

thats lame. my map has alot of brushes that need to be retextured. this is gonna take forever.

Textures are applied at 25% by default. Make sure you're selecting the face, deselecting it makes the boxes go blank.

mine says 25% percent default but it always applies it at 100% unless i put in the value to change it, and that always resets itself

Oh, sorry, I didn't notice this was the HL2 forum.

I had the same problem and just could'nt do it...