I think the post pretty much tells the story. I am novice so I don't understand why I would want any more cuts than necessary but func_detail provides options to cut or not cut and I don't get it. Can someone explain.
Thanks in advance
Camplo
Why would I want my func_detail to cut?
Created 12 years ago2012-02-15 23:41:33 UTC by
camplo
Created 12 years ago2012-02-15 23:41:33 UTC by
camplo
Posted 12 years ago2012-02-15 23:41:33 UTC
Post #303419
Posted 12 years ago2012-02-16 00:36:59 UTC
Post #303422
I did a side by side comparison of a spot that had a few brushed that I turned in detail extruding of a wall. Also in that are were clip brushes that I decided to turn into detail with the setting on 2... I gained 30 w_polys...
You must be logged in to post a response.