The Whole Half-Life
Level design resources for GoldSource, Source, and beyond
Featured game: Half-Life by Valve Software
Goldsource Error: I cannot see my textures History
See all pages See all uploads See all categories

Goldsource Error: I cannot see my textures Last edited 7 years ago2017-12-14 12:25:28 UTC

  1. Wiki
  2. View Page

This article was converted from a previous version of TWHL and may need to be reviewed

  1. The formatting may be incorrect due to differences in the WikiCode processing engine, it needs to be revised and reformatted
  2. Some information may be out of date
  3. After the article is re-formatted and updated, remove this notice and the Review Required category.
  4. Some older articles are no longer useful, or they duplicate information from other pages. In this case, delete the page after merging any relevant information into other pages. Contact an admin to delete a page.
ORIGINAL TITLE: I cannot see my textures

Check, if it is for textures in WC, did you put the texture into a wad of the right format (HL) and install it in WC? If it is for far away textures in the game, did you set the map's max view distance too low? Are you in software mode with more than 800 wpolys in the area? Or do you have too thin brushes or overlapping brushes? Do you have too many wads in WC/Hammer - 8 is the limit? Did you remove the wad from WC/Hammer that the texture is in? Was the texture was over streched or over shrunk, or adjusted to nothingness. If your custom textures are black in the game, did you REMIP them in Wally?

If it is an invisible texture/{transparent check all of these:

Comments

You must log in to post a comment. You can login or register a new account.