The Whole Half-Life
Level design resources for GoldSource, Source, and beyond
Featured map: Riverpool by Rimrook
Goldsource Error: Exceeded MAX_MAP_CLIPNODES History
See all pages See all uploads See all categories

Goldsource Error: Exceeded MAX_MAP_CLIPNODES Last edited 16 years ago2008-10-15 17:46:42 UTC

  1. Wiki
  2. View Page

This article was converted from a previous version of TWHL and may need to be reviewed

  1. The formatting may be incorrect due to differences in the WikiCode processing engine, it needs to be revised and reformatted
  2. Some information may be out of date
  3. After the article is re-formatted and updated, remove this notice and the Review Required category.
  4. Some older articles are no longer useful, or they duplicate information from other pages. In this case, delete the page after merging any relevant information into other pages. Contact an admin to delete a page.
When you get this error message, you've exceeded the maximum amount of Clipnodes in your map.
However, clipnodes can be reduced with a bit of work.

When the maps are compiled all the 3d 'space' a player can get to is broken up into convex regions just like brushes are required to be, alot of them are extremely small or too small for a player, and if you put a CLIP brush over them they don't become clipnodes at all (well really there are still a few intersecting the brush on its surfaces, but the brush can be excluding dozens or hundreds of them at a time).

If the world has had a 'box' placed around it to prevent leaks, its probably causing several thousand (if not 10000+) extraneous nodes and clipnodes to be caused, not only wasting resources but will cause vis to work a lot harder than it needs to. An example map is available, demonstrating how it is possible to reduce the clipnodes in a map. Without the clip brush in place, the map requires over a hundred more clipnodes to define the player-accessable space.

Comments

You must log in to post a comment. You can login or register a new account.