Wiki: light_spot (Half-Life)

This article was converted from a previous version of TWHL and may need to be reviewed

The formatting may be incorrect due to differences in the WikiCode processing engine, it needs to be revised and reformatted
Some information may be out of date
After the article is re-formatted and updated, remove this notice and the Review Required category.
Some older articles are no longer useful, or they duplicate information from other pages. In this case, delete the page after merging any relevant information into other pages. Contact an admin to delete a page.

Point Entity

The light_spot entity allows you to create direct beams of light (like from a, err, spotlight).

Attributes

Name (targetname) - Property used to identify entities.
Target (target) - When an entity is activated, it triggers the entity with the name specified by Target.
Pitch Yaw Roll (angles) - Sets the pitch (up / down), yaw (left / right) and roll (bank) respectively. The compass in WorldCraft / Hammer corresponds to Yaw. The settings are not always (or not all) used.
ZHLT Falloff (_falloff) - This option can change the normal inverse square falloff of lighting in the direct lighting layer with inverse falloff:

1 = inv linear
2 = inv square

Inner Radius (_cone) - The angle of the cone formed around the directional axis. The area inside this cone will contain the brightest light.
Outer Radius (_cone2) - As above, although the area inside this cone will fade increasingly towards the outer edges.
Pitch (pitch) - The pitch of the light (-90 is straight down, 90 is straight up).
Brighness (_light) - The first three 3-digit number are the colour (RGB). The third is the brightness.
Is Sky (_sky) - 0=No, 1=Yes. If Yes, the spot_light will affect the sky brushes, rather than project any light itself.

Appearance (style) 
<TL>
0 = normal 
1 = flicker A 
2 = slow strong pulse 
3 = candle A<TC>
4 = fast strobe 
5 = gentle pulse 
6 = flicker B 
7 = candle B<TC>
8 = candle C 
9 = slow strobe 
10 = fluorescent flicker 
11 = slow pulse, no black</TL>

Custom Apperance (pattern) - Use a string of letters to provide a custom light style (see note).

Flags

Initially dark (1) - If this is enabled, the entity will need to be triggered to work.

Inputs

Outputs

Notes

The Custom Apperance property allows you to enter a string of letters from a to z, representing brightness. If you entered 'abcdefghihgfedcba' then the light would go from bright to dim and back again and then repeat. Complicating things, to use this feature, you must name the light. However, if you then use a trigger to activate it, then it will behave as a normal light.

light_spot (Half-Life) Last edited 9 years ago2015-08-19 00:39:30 UTC