it spins through the object,im not sure what im doing wrong, so im gonna go through it step by step.i should also mention its a fan laying down on something. (fan tut didnt help much :/)
1. i made a fan
2. put an origin brush through it
3. checked the start on and y axis boxes
the only problem i can think of is the origin not being tied to the correct entitiy
fan not rotating around origin
Created 17 years ago2006-10-29 18:08:56 UTC by
3mil
Created 17 years ago2006-10-29 18:08:56 UTC by
3mil
Posted 17 years ago2006-10-29 18:08:56 UTC
Post #201255
Posted 17 years ago2006-10-29 18:12:36 UTC
Post #201256
1.Make the brush that will be the fan
2.Make an origin brush where the axis of the fan will be
3.Tie both together to a func_rotating entity.
4.Modify the settings to your liking.
2.Make an origin brush where the axis of the fan will be
3.Tie both together to a func_rotating entity.
4.Modify the settings to your liking.
Posted 17 years ago2006-10-29 18:14:36 UTC
Post #201257
oh ok i get it thanks, id tie both of them to the same entity but i needed to seperate ones! 
Posted 17 years ago2006-10-30 23:17:32 UTC
Post #201415
ill upload the map later this week, because ive tried both ways and no luck.
Posted 17 years ago2006-10-30 23:27:35 UTC
Post #201416
Try checking different X,Y,Z axis boxes and seeing the results? Also tie the origin to the fan brushes to func_rotating..
You must be logged in to post a response.