Where are these coordinates? Created 19 years ago2004-07-16 18:11:20 UTC by static

My comile log gives me an error and gives coordinates to where the error is. What's the best way to pinpoint where the error is located? I'm not quite sure how to find it and fix it. Thanks in advance.

If it gives a brush number/ent number with the coords, just go to Map-Go to Brush Number... and input the number and then it should take you to the error.

To find a certain point in the world, go to it's center (indicated by blue lines) and add a brush.
Make it equally large in every direction.
Now press [CTRL]+[M], check the 'move' radio button and enter your coords. Hit 'OK'.
You can also try to find them with the mouse. The current coords in one plane of the mouse are displayed at the lower right in the VHE.
This method is quite nerving, though.

Here's the error i'm getting:

WARNING: MakeNodePortal:new portal was clipped away from node@(12,460,-3380)(14,-455,-3148)

I'm sure you've dealt with this issue before but I appreciate the help.
I'm Not sure which #'s to type in. Thank you.

I never get those errors anymore, because I learned to avoid them during the mapping.
It's hard to help here. Those errors are mostly caused by strange worldbrush constuctions.
Check out tommy14's compile error site!
Your error.
It's the best site for finding concerning odd compile errors.

http://www.slackiller.com/tommy14/errors.htm?findthis=MakeNodePortal#portalclip

Tommy14 is always helpful for problems. Bookmark that page.

About four days ago:

You beat me to it, Haz.

And i did it again.

Lol. I'm a bit slow on these things....

Actually, I had left for dinner and left this page open.

It sometimes happens to me, too. Especially when I'm to lazy to read all the other replies.
Diner, eh? I'll eat breakfast in about 6 hours.
yawns