How to make archway? Created 13 years ago2011-08-09 14:25:00 UTC by Bambucha` Bambucha`

Created 13 years ago2011-08-09 14:25:00 UTC by Bambucha` Bambucha`

Posted 13 years ago2011-08-09 14:25:00 UTC Post #297597
A lot of mappers say 'don't carve cylinders'. Then how do i make archway the right way? I made half-cylinder with arch tool, then edited it with vertex manipulation tool, got little bit more wpolys than with carving the archway.
Posted 13 years ago2011-08-09 16:32:35 UTC Post #297603
Carve sucks. Use clipping tool and utilize shift x. Than alt p. If a new error has occured hit ctrl z and try something else.

And yea arc tool should be your best option for an arch. Than clip/ cut it and/or vertex manipulate it.
Posted 13 years ago2011-08-09 20:21:08 UTC Post #297616
You should use this. It's probably possible to carve cylinders and keep everything on grid and free of errors, but not likely at all.
Alabastor_Twob Alabastor_Twobformerly TJB
Posted 13 years ago2011-08-09 23:03:54 UTC Post #297623
I had this problem, It tales some clever vertex manipulation to do, I might make a tutorial if I finish my weapons one first.
Posted 13 years ago2011-08-10 07:55:44 UTC Post #297641
Not that difficult, just clip or VM some blocks around a cylinder.
Jessie JessieTrans Rights <3
Posted 13 years ago2011-08-10 08:04:34 UTC Post #297642
Lol? I'm looking at your methods they all suck. Cmon there's an actual tool for this. All you need to do is use the arch tool, set the value to 180o circle, make it so that there is a round gap in the middle and the round sides on the outside of it, then use the vertex tool to make the arch however you want it.
Skals SkalsLevel Designer
Posted 13 years ago2011-08-10 08:52:49 UTC Post #297645
I was looking on snarkpit for an article about terrain. I remember finding this. Welcome. http://www.snarkpit.net/snarkpower/articles/game/cat/pn/tp/7/Arches
Posted 13 years ago2011-08-10 19:05:20 UTC Post #297675
I did almost the same as dexter's snarkpit link, just did it all with vertex tool, thanks for help.
You must be logged in to post a response.