Carve Last edited 11 years ago2008-06-11 08:13:29 UTC by Penguinboy Penguinboy

This article was converted from a previous version of TWHL and may need to be reviewed

  1. The formatting may be incorrect due to differences in the WikiCode processing engine, it needs to be revised and reformatted
  2. Some information may be out of date
  3. After the article is re-formatted and updated, remove this notice and the Review Required category.
  4. Some older articles are no longer useful, or they duplicate information from other pages. In this case, delete the page after merging any relevant information into other pages. Contact an admin to delete a page.
This is a tool available in Hammer that lets the mapper cut a brush using another brush. Carving with more complex brushes like spikes, cylinders etc., is a huge headache and can cause problems. If possible create each brush individually and / or use vertex manipulation. See Atom's tutorial on Vertex Manipulation, and carve with care.... Having said that, don't be too scared to use it, if used properly it is a wonderful tool.

Comments

You must log in to post a comment. You can login or register a new account.